How to Program a Pontiac G6 Remote Control

1.

Enter your vehicle and close all of the doors behind you besides the driver's door. Be sure to have your keyless remote and ignition key in hand.

2.

Insert and remove the key from the ignition twice in a row and then close and open the door twice in a row.

3.

Insert and remove the key from the ignition again and close and open the driver's door two more times.

4.

Insert the key into the ignition and close the driver's door.

5.

Cycle the key in the ignition "On" and then "Off" and then remove the key from the ignition.

6.

Wait for the locks to cycle to indicate the beginning of the programming sequence.

7.

Press and hold the unlock and lock buttons on your remote for two seconds and then release.

8.

Press and hold just the lock button on the remote for three seconds and wait for the locks to cycle to indicate successful programming.

9.

Repeat steps seven and eight to program any additional remotes and open the driver's door to end the programming sequence once you are finished.

Keyless entry technologies since the 1990s have become popular on vehicles around the world. Among the Pontiac cars that include keyless-entry system capabilities is the G6. With the G6's keyless-entry remote, you can control your door locks, panic alarm and automatic starter from inside of your house or from as far as a couple hundred feet away. Programming your remote can be done in just minutes and will yield you a ready-to-use device immediately.